Feedthroughs

Feedthroughs


FC Series PBF (Permanent Bulkhead Feedthrough)—Features/Specifications
Common to all FC Permanent Bulkhead Feedthroughs (PBF)

  • Ferrules—Precision machined zirconia
  • Body Material—316 series stainless steel
  • Universal threaded coupling
  • Supports single and multi-mode fiber
  • Typical light loss < 1dB
  • 500 Mate/Demated cycles
  • Operating Temperature: -40°F to 185°F (-40°C to 85°C) with 0.5dB maximum insertion loss
  • Waterproof—100% leak tested
  • Pressure—1000 psig pressure with no signs of leakage
  • Hermetically sealed with or without connector attached, with no detectable leaks at 1×10-9 cc of helium / sec with a permeability rate of 1 X 10-7 cc of helium/sec.
FCDryHP-Feedthrough
Specific—Features/Specifications
  • FC-DRY™ HP PBF Short
    - Minimum Bulkhead Thickness – .125 in
    - Maximum Bulkhead Thickness – .395 in
500-SFC-S1-B01-000A_p2
  • FC-DRY™ HP PBF
    - Minimum Bulkhead Thickness – .125 in
    - Maximum Bulkhead Thickness – 1.000 in
500-BFC-S1-B01-000-A1
  • FC-DRY™ HP PBF Right Angle
    - Minimum Bulkhead Thickness – .125 in
    - Maximum Bulkhead Thickness – .550 in
500-RFC-S1-B01-XXXA_p2
Specification Download

 

ST Series PBF (Permanent Bulkhead Feedthrough)—Features/Specifications
Common to all FC Permanent Bulkhead Feedthroughs (PBF)

  • FerrulesPrecision machined zirconia
  • Body Material316 series stainless steel
  • Supports single and multi-mode fiber
  • Typical light loss < 1dB
  • 500 mate/demated cycles
  • Operating temperature: -40°F to 185°F
    (-40°C to 85°C) with 0.5dB maximum insertion loss
  • Waterproof100% leak tested
  • Pressure1000 psig pressure with no signs of leakage
  • Hermetically sealed with or without connector attached, with no detectable leaks at 1×10-9 cc of helium / sec with a permeability rate of 1 X 10-7 cc of helium/sec.
STDryHP-Feedthrough
Specific—Features/Specifications
  • ST-DRY® HP PBF Short
    - Minimum Bulkhead Thickness – .125 in
    - Maximum Bulkhead Thickness – .500 in
500-SST-S1-B01-000-A1
  • ST-DRY® HP PBF
    - Minimum Bulkhead Thickness – .125 in
    - Maximum Bulkhead Thickness – 1.125 in
500-BST-S1-B01-000-A1
  • ST-DRY® HP PBF Right Angle
    - Minimum Bulkhead Thickness – .125 in
    - Maximum Bulkhead Thickness – .590 in
500-RST-S1-B01-XXX-A1_A
Specification Download

 

EXPORT RESTRICTIONS: These parts may be subject to the United States Munitions List (USML) and may be subject to the ITAR requirements that can be found in Subchapter M, Title 22, Code of Federal Regulations, Parts 120 through 130 (22CFR 120-130).  A license from the US Department of State may be required to Export these products.